Lightweight AP Template - FlexConnect Parameters error
I created a LAP Template in NCS to configure some new 1142 LAPs that were installed in a remote office. These LAPs need to be in FlexConnect mode with VLAN support. The template is being applied with partial success on every access point. Details of the partial success say the FlexConnect Parameters fail with the following error.
Provision Failure: com.cisco.wnbu.server.common.errors.ObjectNotFoundException cannot be cast to com.cisco.wnbu.server.common.errors.InternalException
Am I doing something wrong?
The FlexConnect portion of the template has VLAN Support enabled, Native VLAN ID, and the Profile Name-VLAN Mappings configured.
Prime NCS version 188.8.131.52
Access Points are AIR-LAP1142N-A-K9s running 184.108.40.206
Re: Lightweight AP Template - FlexConnect Parameters error
Any updates to share in this case?
Make one template just to reconfigure the AP to Flexconnect without settings, apply and reboot. Then to make another template which do the FlexConnect settings you want to add. Can not be done with just one template...(as far as I know)
Because the FlexConnect-settings cant be applied if the AP isnt a FlexConnect already.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...