i want to create 2 ssids on and limit bandwidth to 10 percent using a policy map on a 1240 or 1230 series ap. i tried creating a class and using the match vlan then under the policy configuring it with the bandwidth percent command, then applying it to the sub interface on that radio for that vlan. it takes the command but it doesn't show up in the running con fig and it doesn't seem to be working. are these commands supported? is it possible to limit bandwidth right over the air on a particular vlan using this access points?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...