Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Link Drops

5.2dBi Mast Omni at Central Site, 13.5dBi at 2 Remotes. ONe remote a problem. Distance to problem remote is .6Km. Signal strength shows 50%.

Keep getting Lost Authentication, then it associates again. Dropped speed down to 1Mbps., but still drops out evry 3-4 hours.

There are high Tension Power lines running above the path between the two site. Is this an issue?

Bob

1 REPLY
Cisco Employee

Re: Link Drops

Bob,

It is possible that the power lines are an issue but check everything else first.

Which firmware version are you using ?

Do you have a high rate of CRC errors or discards ?

What is the signal quality ? ( run the antenna alignment test)

Anything close to the frensel zone ? what showed up in your site survey as potenial problems ?

How long is your coax at both ends.

What do you see in the channel activity test ? Have you selected the least congested channel ?

Has this always happened since it was installed or just started

I know this is a lot of questions but these are the first things you need to check when you troubleshoot bridge links

107
Views
0
Helpful
1
Replies
CreatePlease login to create content