We have LinkSys access points in two remote buildings. We now want to connect the two buildings with a Cisco Aironet 350 Bridge. The bridge link works fine. The problem is every 30-60 minutes the LinkSys devices have go to a wonderful 14.4k (or slower) modem speed type connection. The LinkSys is on default Channel 6. The Aironet is on 1 and we've also tried 11. We've also tried 1 for Cisco and 11 for LinkSys. No options work. We're using Yagi antennae between the two locations and the distance is about 500 feet. Wired computers aren't affected by the LinkSys problem and the Cisco connection stays up. Only the LinkSys wireless clients are affected.
1. Pinging from wired through wired at the remote location ALWAYS works.
2. Pinging from wireless through the cisco wireless to a wired computer fails every 30-60 minutes. The LinkSys devices have to be unplugged, wait 5 seconds and plugged back in. The problem immediately goes away until the next 30-60 seconds.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...