I am attempting to install a Linksys WAP4400N access point on my network. The switch is a Cisco 3750G. Every time we plug it in, the connection light on the 4400N comes on and then drops off. On the switch, in Cisco Network Assistant, the port connected to the WAP goes yellow . When we take the port out of the VLAN, the connection stays on but it is not on the network. What must I do to get the WAP work on the VLAN on my network? All workstations work perfectly.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...