Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Loading Problems

I have a new 1242 and I can never get to a config prompt. I have reset the ap and I still get the same issue. All I get is the following below.

*Mar 1 00:20:26.798: %LINK-3-UPDOWN: Interface BVI1, changed state to up

*Mar 1 00:20:27.799: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, changed state to up

*Mar 1 00:20:31.675: %LINK-3-UPDOWN: Interface BVI1, changed state to down

*Mar 1 00:20:32.674: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, changed state to down

1 REPLY
Silver

Re: Loading Problems

BVI is the virtual interface. Try to upgrade the access point to a higher version, Reset it again and try again

149
Views
0
Helpful
1
Replies
CreatePlease to create content