I recently installed two BR350 Bridges to connect a remote site.
It seems that if I stay in the remote bridges web page very long looking at settings I lost the connection and can no longer ping the bridge. The root bridge still shows the association but the only way to regain access via IP is to power cycle the bridge. The bridges have static IP addresses. Specifically I updated the firmware to possibly address the situation... after loading on the root (local) bridge it rebooted itself and I regained connection. After loading the firmware on the remote I lost my connection and an hour later still could not ping the bridge until I manually power cycled it.
If possible, try swapping the bridges to see if the bridge that was in repeater mode locks you out when it is in root mode. If it still locks you out then you may need to replace it with another bridge. You should as well check the antenna and antenna connections for the repeater.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...