Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
369
Views
0
Helpful
0
Replies

Lost Channel and Power settings after Wireless Controller Upgrade

ANDREA GELATI
Level 1
Level 1

‎11-23-2009 12:56 AM - edited ‎07-03-2021 06:16 PM

Hi all, I have a problem with configuration of a couple of WLC4404-100-K9.

After an upgrade from the version 5.2.178.0 to the version 5.2.193.0, I lost channel and power static settings for each AP, with Auto RF disabled.

This is a normal behavior or is a bug?

Regards

Marco Bergonzoni

Labels:
0 Helpful
0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card