Since you actually had it working, I have a question. I just purchased a new one and it does nothing.... Cannot even connect to it via console with Hyperterminal (reviewed setting required). When plugged into the ethernet, I get a blinking on the switch but nothing on the device at all. I am using switch without inline power so I have the adapter in place to provide power. I am trying to figure out if I am missing something or if its DOA.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...