I am aware of the controller command "config ap username 'user' password 'pass' all/cisco ap"
However I am wondering if it is possible to actually get a login prompt from the lwap console. Entering the command specifies a username, however you are not prompted for the username from the lwap console. I realize that you are a privilege 1 user, however I would like to prevent access from the Lwap console port completely.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...