Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LWAP Rogue Detector AP - alerting

Has anyone figured out a way to get an AP set in Rogue Detector mode to stop alerting radio down/assoc/disassoc. The radio is down I understand but if you leave an AP in RD mode to monitor wired traffic you are going to get a flood of alerts...

Using v4.2.176. Thanks,

2 REPLIES

Re: LWAP Rogue Detector AP - alerting

You can change the sigs under

Security-> Wireless Protection Policys-> Standard Sigs -> Click on the number to change

I hope this helps

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
Hall of Fame Super Gold

Re: LWAP Rogue Detector AP - alerting

In addition to George's post, try this:

Management > SNMP > Trap Controls

Go to the Client Tab for the Association and go the the AP Tab for the Radios.

Hope this helps.

126
Views
0
Helpful
2
Replies