Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LWAPP 1242 radio 0 shows down

I have cisco LWAPP 1242 AP already joined controller but 802.11b/g shows down on the radio 0 interface. I tried to enable it but it comes with an error" Error in enabling admin status". I have resetted the AP to factory default settings and even replaced with NEW AP. Any comments would be appreciated.

3 REPLIES
Hall of Fame Super Silver

Re: LWAPP 1242 radio 0 shows down

Do you have the global 802.11bgn network enabled? It's the correct country code on the AP? Been seeing that lately. Also, console into the ap while booting up and post the output.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Gold

LWAPP 1242 radio 0 shows down

Only radio 0 right?

Can you please tell us what is the domain of your WLC set for?  Please post the command "sh inventory" taken from the WAP in question?

New Member

LWAPP 1242 radio 0 shows down

Issue got fixed by disabling cdp on accesspoint. Thanks for your support

802
Views
0
Helpful
3
Replies
CreatePlease login to create content