First off, my wireless is deployed in a noisy environment (tire manufacturing).
That being said, whenever I run an 802.11 MAC counters report in WCS it shows the number incrementing. I know one way to clear the counters is to reboot the APs, but that is not desireable. Do the counters clear themselves once they reach a certain point? Is there a way to clear the counters without rebooting the APs (LWAPP). If the counters get too high can it cause an issue with the AP?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...