I have a network with 1242 AP:s running lightweight, and a 4400 WLC. I am running Indoor Mesh.
Can I have a lwapp AP acting as a workgroup bridge in the mesh network? What I want to do is to provide ethernet-connection to 1-2 PC:s in a remote building by using a 1242 LAP that connects to a MAP, to make it communicate with a server on the LAN where the RAP and WLC is stationed.
PC === WGB --- MAP --- MAP --- RAP === WLC === server
(where = is ethernet and - is wireless)
How do I configure a WGB in the WLC when running Indoor mesh?
I havent tried this myself on the 1242 but if it works it would be the same as for a 1510. Enable bridge mode on the configure AP screen. This enables the ethernet port to pass bridged traffic. Like I said, I havent tried it myself.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...