Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

LWAPP Ap boot problem

I have a 1252 Ap that was booting to LWAPP software and connecting to a 4402 controller. It suddenly stopped booting into the LWAPP code. I can reach the Ap by telnet and it seems to boot to Autonomous mode. Is there any way to start the boot into LWAPP from the command prompt? Thanks in advance.

3 REPLIES
Cisco Employee

Re: LWAPP Ap boot problem

Are you sure AP turned to Autonomous from LWAPP ... that;s weird ..

Can u run folowing cmds on AP

1. Debug lwapp client events

2. show lwapp client rcb

Just wanted to make sure it is not lwapp :)

Thanks

Vinay

New Member

Re: LWAPP Ap boot problem

Both commands come back as invalid. I'm also sitting at an ap# prompt.

New Member

Re: LWAPP Ap boot problem

I've figured out the problem....One of my partners reloaded the Ap with Autonomous code which explains why it was autonomous. I knew it just doesn't happen. Thanks.

204
Views
0
Helpful
3
Replies
CreatePlease to create content