Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LWAPP upgrade on AP 1131AG failed

Hi

The LWAPP-upgrade on a AP 1131AG faield with the following error message on the upgrade-tool:

"AP does not have supported radio"

On the AP is still the autonomus image.

Does anyone have an idea?

4 REPLIES
Hall of Fame Super Gold

Re: LWAPP upgrade on AP 1131AG failed

Are you trying to upgrade from Autonomous to LWAP using the upgrade tool?

Upgrading Autonomous Cisco Aironet Access Points to Lightweight Mode

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html

Hope this helps.

Re: LWAPP upgrade on AP 1131AG failed

this was a message we were getting all the time when trying to convert the 1230 that have radios not supported in LWAPP (the old .a radio).

Per the release notes, the 1131AG is supported for conversion, I'm not sure why you get this message.

Nevertheless you still should be able to convert the AP.

Make sure to follow the procedure send by leolaohoo

New Member

LWAPP upgrade on AP 1131AG failed

Hi,

Me too getting the same error. Please check if your AP is damaged one?

Regards

Mangesh Bhende

Re: LWAPP upgrade on AP 1131AG failed

while the AP is running iOS can you pull a show controllers dot11radio 0 and 1?

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
1838
Views
6
Helpful
4
Replies