Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LWAPP Upgrade Tool HELP

Does anyone know if I can pass parameters to the Upgrade tool so I don't have to type in the same information every time I run it? Especially since you have to close and re-run it each time due to Cisco documented memory leaks!! I have 300 1120s to convert so any tips would be much appreciated.

5 REPLIES
Silver

Re: LWAPP Upgrade Tool HELP

Do you have the most recent version of the upgrade tool? I'm pretty sure that it no longer needs to be reset after each run. Even then, you can run all 300 access points in a single run, so you shouldn't need to repeat the process for every single AP.

To answer your question, I do not know of any way to pass parameters in externally.

New Member

Re: LWAPP Upgrade Tool HELP

Latest version is v3.4. Release Date: 24/Apr/2008

This is from the release notes:

The LWAPP upgrade tool does not release Windows operating system memory resources when the upgrade process is complete. Memory resources are released only after you exit the upgrade tool. If you upgrade several batches of access points, you must exit the tool in between batches to release memory resources. If you do not exit the tool in between batches, performance of the upgrade station quickly degrades because of excessive memory consumption.

The upgrade tool can handle up to 6 access points at one time.

Silver

Re: LWAPP Upgrade Tool HELP

Oh, so they still recommend it. I thought you were using an old version that used to actually close at the end of each session. That was version 1.x I think.

You can do 6 access points simultaneously, but you can still give it 300 to do in a single run. Your text file just needs to list all access points. So it will do 6 at a time, and when each one is done it will move on to the next one on your list.

Hopefully that makes sense - the point is that regardless of how many you do at once (1-6), it will sequentially upgrade each access point in your IP file until all 300 are done.

New Member

Re: LWAPP Upgrade Tool HELP

You don't have WCS? Using WCS is the easiest way to upgrade... (and manage your 300 APs afterwards)

New Member

Re: LWAPP Upgrade Tool HELP

WCS seems to migrate my 1131s 100% but I have had less than 10% success migrating 1120s with WCS.

1027
Views
0
Helpful
5
Replies