How would I disallow LWAPP APs (managed by a WiSM) in a remote areas from supporting my guest access WLAN, without diabling the guest access WLAN globally? Right now I have the same WLANs defined on both WiSM controllers and a centralized WiSM at the core for the campus. Thanks.
How can one verify that a WLAN is NOT active on the APs it shouldn't be on?
I have run the WLAN override on the WCS, which is reported to be successful, yet the WLAN that should only be on TWO APs is showing up on other APs. (not to mention that that SSID is not supposed to be broadcast anywhere!)
When I look at the APs on the controller there is no indication of which WLANs are active on the AP.
How can I verify which WLANs are actually active on any particular AP?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...