Cisco Support Community
Community Member

MAC Address Filtering on Cisco Aironet 1200 series access points

Hi there,

I am using a Cisco AP

Product/Model Number: AIR-AP1231G-A-K9

Top Assembly Serial Number: FHK1015J0NA

System Software Filename: c1200-k9w7-tar.123-4.JA2

System Software Version: 12.3(4)JA2

Bootloader Version: 12.3(2)JA4

I am using WEP 40-bit authentication

I am able to get the IP address and also able to go online

As and when I try to use MAC-Authentication and configure filters and apply them on 802.11g, the clients are not able to pull up IP addresses,

Instead I am getting apipa address on the clients.

The same model accesspoint with the same software and model in another location i am able to use it fine.

I am not able to understand what might have happened??

I had done a lot of R&D on this, tried reconfiguring, tried re-connecting etc

Please suggest me a solution for this

Thanks in advance


CreatePlease to create content