I have a Cisco 3200 MAR. The configuration inside the 3200 MAR is [Wireless+Router].
When MAR is connected to the APs on the otherside for the first time, bvi1 is getting an IP address via DHCP and Interface between Wireless and Router (vlan 1) getting an ipaddress. Its fine till now.
But when the MAR is moving and connected to the second network, bvi1 is requesting new IP address and successfully getting an IP address. But the interface between wirless and MAR is not broadcasting the new DHCP request, it still keeping the same IP address unless you shut the interface and open the interface.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...