I'm deploying 20 unit of Cisco AP 1220. Basically, almost all the configuration are the same except the ip addresses and channel. Is there any way to do it in script form.
I try to download the configuration with non-default setting from the access point, the SNMP string and user account in user manager are not downloaded at all. Is there any way to key in this information into ini file which I will use to upload to each AP?
There is a method that the WLSE documents: basically the AP's use DHCP to find a boot server and load a basic configuration from it. Then the WLSE or scripts you write can go back and set the configurations that you want.
What I did is use a terminal emulator (like Tera-term) that has a scripting language - hook a pc up to the AP serial port and save a basic configuration to the AP, before installing in the ceiling (hostname, ip address, turn radio off, etc.). Then I went back and updated the configuration with scripts or WLSE.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...