Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Max. Distance & Throughput using bridge+solid dish (ETSI vs. US Standard)

Using ETSI standard, it it possible to connect 2 sites (distance=10KM) using bridge+solid dish antenna with throughput between 5Mbps to 11Mbps?

I was told that the information in Cisco website was tested based on US standard, and if the solution is based on ETSI standard, this might not working.

Thanks.

3 REPLIES
New Member

Re: Max. Distance & Throughput using bridge+solid dish (ETSI vs.

Re: Max. Distance & Throughput using bridge+solid dish (ETSI vs.

Thank you for the info.

However, since ETSI standard is applicable for certain countries, including Malaysia, the Aironet International Power Compliance Chart shows that Malaysia falls under the same group with US.

So, if I were to use use the xls calculation formula (distance + quality/throughput) , should I use ETSI or US standard? Theoritically it might be working.

Thanks.

New Member

Re: Max. Distance & Throughput using bridge+solid dish (ETSI vs.

If you are going to comply with the ETSI limits, select that choice. The succeed/fail math is the same; all that changes are the regulations.

190
Views
0
Helpful
3
Replies
CreatePlease login to create content