description TRUNK LINK TO ROUTER switchport trunk encapsulation dot1q switchport mode trunk storm-control broadcast level 50.00
description SWITCH MANAGEMENT ip address Y.Y.Y.Y 255.255.255.0
AP connects to our 3560 switch and assign VLAN 990.
Switch is manage using interface Vlan999 with ip address Y.Y.Y.Y 255.255.255.0
Our 3825 router has 2 GigEthernet Interfaces, LAN (Switch connection) and WAN (Internet Connection).
VLANs are separated on the router LAN interfaces using sub-interface and assigning dot1q VLAN ID.
We want to bridge our client VLAN 100 (wired) by creating a wireless client on the same VLAN 100 under the Integrated-Service-Engine1/0. This is to reduce the use of physical switch ports on our 3560. Clients on both wired and wireless can be assign on the one (1) VLAN ID.
Is this possible with my setup?
Right now, all wireless clients are on VLAN 995 with 192.168.10.X as the DHCP IP Address. I want to join wired and wireless under VLAN 100. I read this can be done using Bridge-group.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...