Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Mesh networking

Equipments being used:

1) Cisco 2106 WLAN controller

2) Cisco 1131AG access points (LWAPP mode)

3) Cisco catalyst 2950 switch

Hi,

My setup is as follows:

My access point is registered with the WLAN controller via the switch. When i try to change the mode of the access point to bridge. It does not accept the change. My aim is to create a mesh network using 1131AG access points.So my question is:

Can I setup a mesh network using Cisco 1131AG access point in LWAPP mode or do i need to change them to autonomous mode?

Any documentations or comments will be helpful.

Thanks in advance.

Regards

Sri

5 REPLIES
Cisco Employee

Re: Mesh networking

You should be able to setup the 1130 at a Enterprise Wireless Mesh. Take a look at this link for the F&A for Enterprise Wireless Mesh:

http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps6521/prod_qas0900aecd806bde44_ps6087_Products_Q_and_A_Item.html

Re: Mesh networking

Hi Sri

You need to upgrade your ios to mesh ios which is available in cisco site

you can connect up to 4 ap's ads mesh access point

New Member

Re: Mesh networking

Thank You for the help

Now, i can finally setup my mesh network :D

Re: Mesh networking

The mesh trains are due to reconverge shortly so you will have all the 5.1x features available as well.

New Member

Re: Mesh networking

You can do this but you need 4.1.191M. It's the code that will enable you to put the AP in bridge mode. Here are the release notes.

451
Views
10
Helpful
5
Replies