Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Minimum Connect rate 1140AG

I would like to limit all connections to a minimum of 9Mbs. I tried using the speed basic-9.0 command on the dotradio 0 interface. This seemed to limit me to only 9 and nothing better. Is there a better way to configure this?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Minimum Connect rate 1140AG

Same thing but without the 11.0, since that's the only rate that's b/g. Just make the 9.0 rate the basic one.

3 REPLIES
Silver

Re: Minimum Connect rate 1140AG

The speed command is for listing out all allowed data rates. In other words, you need to list all speeds above 9Mbps as well. It would sure be nice if there was a 'minimum' option!

A warning about the "basic" prefix - basic means that a radio must support that data rate in order to connect. If you don't want 802.11b clients to be able to connect, you're fine. Otherwise, you'll want to list the basic-11.0 command instead of basic-9.0, since 802.11b clients can't support 9Mbps rates.

Here's the correct config for your scenario:

802.11b clients not supported:

speed basic-9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0

802.11b clients supported:

speed 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

Jeff

New Member

Re: Minimum Connect rate 1140AG

What would the speed syntax be for the A radio?

Silver

Re: Minimum Connect rate 1140AG

Same thing but without the 11.0, since that's the only rate that's b/g. Just make the 9.0 rate the basic one.

168
Views
0
Helpful
3
Replies
CreatePlease to create content