I have 2 BR1310G's that are currently part of a test network. Eventually we'll deploy outside but for now I need these two bridges to work inside our building on our test network. The question is, what is the minimum distance these should be apart so they don't cook/fry each other?
Why don't you stick them within a few feet of each other and turn the transmitting power down for your test? That would seem to make the most sense to me.
Or, if you wanted to get fancy, figure out how far the buildings are apart, calculate the loss DB of the air inbetween them. Do some research, figure out what material (ie glass, wood, whatever) has a similar loss db. Build an enclosure out of the material. You may need to only build one enclosure depending on the distance between the buildings. If you need additional signal loss, build another...I think you get where I'm going with this.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...