Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Mobility Anchor will not stay up

I have been setting up our new wireless environment... employee access and Guest access and folling the "deployment guide for Cisco Guest Access". I am using version 4.26 of the controller code and the Mobility achor control and data paths will come up and stay up for several hours but then they go down. We have all the appropriate ports open in the FW between our inside controller and our DMZ controller. Is there a bug in the 4.26 code? Any ideas would be appreciated.

Thanks

Alex

1 REPLY
Silver

Re: Mobility Anchor will not stay up

The local EAP server is not available if there is a global external RADIUS server configuration in the WLC. All authentication requests are forwarded to the global external RADIUS until it is available. If the WLC looses connectivity to the external RADIUS server, then the local EAP server becomes active. Following link may help you

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080851b42.shtml

184
Views
0
Helpful
1
Replies
CreatePlease to create content