Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Mobility group membership

I have 4 WLC's deployed :

1. AnchorWLC - WLC4402 anchor in a DMZ for guest access

2. WLCA1 - WLC4402 on SiteA

3. WLCB1 - WLC2006 on SiteB

4. WLCB2 - WLC2006 on SiteB

SiteA & SiteB are geographically separated.

On all WLC's there is the same mobility group 'group1' with the following group members:

1.on AnchorWLC: group1 members:WLCA1,WLCB1,WLCB2

2.on WLCA1: group1 members: anchorWLC

3.on WLCB1: group1 members: WLCB2,anchorWLC

4.on WLCB2: group1 members:WLCB1,anchorWLC

As SiteA and SiteB are geographically separated I have not included internal(non-anchor) WLC's that are on siteA in the mobility group created on WLC's on SiteB and vice versa . The only WLC that has all controllers added to his mobility group is the AnchorWLC as guest access is needed from both siteA and siteB.

Is this a valid config(anayway it is working...) or is it recommended to have 2 different mobility groups, one for each site(A & B) and create 2 seperate mobility groups on the anchorWLC ?

1 REPLY
Silver

Re: Mobility group membership

I would recommend going for two separate mobility groups. Even though it is working since it is geographically separated, its always better to have different mobility groups.

143
Views
0
Helpful
1
Replies