Mobility group only works using management interface?

[ecarbajo]

Hello,  in order to stablish the control traffic between 2 WLC-5508, it's necessary to use the management interface??
It's possible using a dynamic interface o service port ?

I think it only works with management interface,  but I don't understand the meaning of this text in the Configuration Manual:

"Mobility control packets can use any interface address as the source, based on routing table."

Thank you,

[Scott Fella]

No... mobility communication is done only with the management interface.

Thanks,

Scott

*****Help out other by using the rating system and marking answered questions as "Answered"*****