I have an 1131AG (autonomous) that was previously configured with the mode button disabled. As a result, I cannot hold it down on power up to restore a default configuration. I do not know the login for the AP to undo the configuration of the mode button. I tried booting and pressing ESC and CTL-Break to see if I could get ROMMON like you would on an earlier 1200 series, and no dice. Anyone know a way around this? I was able to update the IOS, but of course that doesn't affect the config.
Thanks for the reply. The last sentence of my original post indicates that I have already updated the OS using the recovery method. In addition, upgrading the IOS alters what is stored in flash. The configuration (and hence the password) is stored in NVRAM. Therefore, updating the IOS has no effect on the configuration.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...