I was asked to 'fix' a BR500 implementation with poor signal strength.
I need to improve the System Operating Margin by adding gain to the receive side, but the manual does not show dual connectors (like the 340/350), so I can't do it unless the card inside has dual MMCX connectors like the 340/350.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...