When in bridge mode, APs only need a single SSID to carry all VLANs. Delete two of the SSIDs, and remove the VLAN configuration from your remaining one. Be sure to configure "infrastructure-ssid" under the "dot11 ssid SSID_NAME" sub-command line.
You'll still need to make sure that you have the proper subinterfaces and bridge-groups. Let me know if that works, and if not please feel free to post your configuration and we'll get it resolved.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...