Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Movinn a LAP from a WLC to another WLC

Is it possible to move a LAP associated to a WLC to another WLC?

Can i do it from WLC or WCS?

thanx

marcello

8 REPLIES

Re: Movinn a LAP from a WLC to another WLC

You can do it from either. change the primary controller setting under the AP properties to point to the new controller and then save and reset the AP

New Member

Re: Movinn a LAP from a WLC to another WLC

I have done as you suggested, specifing only as primary the desired WLC.

The LAP, which was configured by priming procedure, indeed still joints to same WLC, though its ip address was inserted in the controller list.

WLC software version is 5.0.148.0

best regards

marcello

Re: Movinn a LAP from a WLC to another WLC

Have you tried reseting it back to defaults?

New Member

Re: Movinn a LAP from a WLC to another WLC

Yes, the reset has be done in all the possible ways.

marcello

New Member

Re: Movinn a LAP from a WLC to another WLC

Does the AP have a self signed certificate? If yes, make sure it is on both WLC's.

Hall of Fame Super Silver

Re: Movinn a LAP from a WLC to another WLC

Place the ap on the same subnet as the WLC you want it to join and set the WLC as the master. the ap will need an IP on the subnet and should be able to join this way. If this ap has a SSC, you will need to add that into the WLC.

-Scott
*** Please rate helpful posts ***

Re: Movinn a LAP from a WLC to another WLC

Verify that the 1st WLC is not setup as a "master" controller too

Movinn a LAP from a WLC to another WLC

335
Views
0
Helpful
8
Replies
CreatePlease to create content