Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multiple SSID through autonomous Repeater

I have an 871W setup for remote users via DMVPN. The WLAN radio has two SSIDs

- One for corporate access (EAP-FAST) terminated via DMVPN at the HQ.

- One for local home usage (WPAv2 PSK), which gets NAT to the local internet connection.

Some homes are too big to be covered with a single 871W, I need to extend that WiFi reach.

I'm planning to use an Autonomous AP1131G in bridge mode to extend those two SSIDs.

Have you guys done it? Any recommendations? I don't seem to find documentation on how to extend multiple SSIDs through a repeater.

2 REPLIES
Hall of Fame Super Silver

Re: Multiple SSID through autonomous Repeater

You can't..... only one SSID can be used which will also be the SSID that will connect back to the root. If you were doing bridge to bridge, that would be different and you would be able to pass multiple vlans, but you are going from and 871W to a repeater....

-Scott
*** Please rate helpful posts ***

Re: Multiple SSID through autonomous Repeater

Hello,

I was wondering if you had a scrubed version of your config. We are trying to do this very thing and would save a ton of time if we could see an example of the dual ssid. Thanks

512
Views
0
Helpful
2
Replies