Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

My Cisco Aironet 1100 Series Access Point

I tried it but still problem. The LED light say Ethn: RED Status: Green Radio: RED That Cisco IOS image file not found, help me please and show me how to...

4 REPLIES
Bronze

Re: My Cisco Aironet 1100 Series Access Point

If the wireless device has a firmware failure, you must reload the image file using the Web browser interface or on 1100 and 1200 series access points, by pressing and holding the MODE button for around 30 seconds. You can use the browser interface if the wireless device firmware is still fully operational and you want to upgrade the firmware image

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_8_JA/configuration/guide/s38trb.html#wp1038660

New Member

Re: My Cisco Aironet 1100 Series Access Point

thanks

New Member

Re: My Cisco Aironet 1100 Series Access Point

Looks like in my case is not working.

I deleted the ios image form the aironet device from command line when i was trying to updgrade it.

Now the aironet 1100 keeps rebooting.

I've tried to hold down the mode for 30 seconds goes red, but keeps rebooting.

Please help if there is anything i can do to fix it.

Thank you,

zeek

Bronze

Re: My Cisco Aironet 1100 Series Access Point

try this

You will need to set up a tftp server with the image you want to load the AP with.

the document at this link details the proceedure.

http://www.cisco.com/en/US/docs/wireless/access_point/1100/installation/guide/1100hig6_book.pdf

Go to Reloading the Access Point Image in the troubleshooting autonomus accesspoints, there are detailed instructions.

HTH

Bill

418
Views
4
Helpful
4
Replies
CreatePlease login to create content