Does anyone know how to get around the issue of Apple IPhones getting Internet access without changing the iPhone settings? I know about changing the SSID settings on the iPhone to get to work but feel this is not good in a hot site location. Thanks for any advice.
This for guest IPhone. I don't think that our guest should have to modify there default settings to be able to log in. The NAC guest server is not giving out a username password to the IPhone once they hit the accept button. I put a test guest up and used the anchor to push out a splash page and have no issues with the IPhone. I have done debug clients off the anchor and see no reason for this. Cisco is looking into the problem but we are running out of time and will soon pull the NAC.
They connect to the SSID ok. They also get our splash page with accept button. We have the NAC set to give out username password once they hit the accept button. The IPhone does not get the username password once they hit the accept button unless the IPhone changes it default settings.
I just used the anchor controller to go out the Internet and bypassed the NAC server and we have several hundred guest on and have not received one complaint. Before we had less guest on and had many complaints from the apple community. I can't believe that no else has not seen this and thinks it ok for a guest to make changes to their device in order to get on the Internet. I have a case open and engineering is looking into my debugs.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...