I bought a NAS using Samba and FTP server and plug it on one ethernet port on my 877W router. I can see the shared drive on every computer plug in to my router but can't see it on my wirless laptop or clients. I can see all devices (printers, SAT receivers, access point, etc..) wired to my router except the NAS. Anyone can help me on how to configure my 877W to see the NAS?
Thanks for replying.... Can't ping NAS from wireless computer. I already disabled the firewall and its the same. At the moment I'm running IOS ADVIPVERVICESK9-12.4.9T. Do i still need to upgrade this, i think the latest is 12.4.15T? Also, I connected the NAS to an access point which is connected to my Cisco 877W as a client and it works fine. I think its my running config but I'm still not that good in setting it up. Do you know how to add the NAS in the running config? Attached is my running-config.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...