Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Network Setup for a 1232AG config with multiple AP's

I'm looking to deploy a temporary outdoor network using 1232AG radios, with only one radio connected to Ethernet & Internet. All the other radios will have a A radio connection to the parent. And their

G radios will advertise for Client Access. Ultimately I'd also like to have the local ethernets active on each of the remote Radios, so that a switch could be setup for people who don't have Wireless.

So the questions, Is this type of setup even possible? If I use the A radios for back haul, and the G radio for Client Access, does the Ethernet get disabled?

What station-role in the network should each of the radios play. Ultimately I believe we could have different SSID's and IP Subnets for each AP, but if we kept them all the same, can we make this one big Bridge? So that someone can Roam between AP's. Granted I don't have the funds for Wireless Lan Controller. Sugestions?

1 REPLY
Hall of Fame Super Silver

Re: Network Setup for a 1232AG config with multiple AP's

So what you are trying to do is have some sort of MESH outdoor wireless, but using the 1232AG? Don't think you can do this by using the bridge role. You would have to go bridge to bridge and then have an ap connected to one of the bridge to handle users...

-Scott
*** Please rate helpful posts ***
147
Views
0
Helpful
1
Replies