I have been asked to make some changes to a 1310 AP at a new site. When I try to browse to the device, I get the login screen, but when I put in the username and password it say :not authorized. I can telnet into it and the username and password work. Could browsing be turned off? How do you turn it back on? Is there a different level of password for browsing? Any Ideas?
Try not entering a username and type the enable secret in for the password. It might be configured to ask for the enable secret instead of local authentication. Default enable secret is "Cisco" (note the capital C).
Once telnetted in, you can check to make sure that HTTP(S) is active by looking for the commands:
(no) ip http server
(no) ip http secure-server
These commands would be toward the end of the configuration. You can disable/enable them by typing them into the config line without the "no".
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...