Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

No flash files on Cisco 1200

I was trying to update the firmware on my 1200, and now it says "The system is unable to boot automatically because there

are no bootable files to boot.

it sits at a "ap:" prompt and will not allow me to enter "enable" mode. HELP!

2 REPLIES
Gold

Re: No flash files on Cisco 1200

Your easiest option would probably be to reload the image with the mode button procedure

http://cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43trb.html#wp1038660

Community Member

Re: No flash files on Cisco 1200

Thanks Dan,

I just found the same doc minutes ago.

149
Views
0
Helpful
2
Replies
CreatePlease to create content