Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

No Heat Maps being displayed in WCS

WCS 4.2.81.0

WLC 4.2.112.0

Loc 3.1.36.0

I have a very large map with currently 40 APs placed on it. Tt will have close to 80 when completed.

Layer that are on:

AP

AP Heatmaps

Clients

Rogue APs

Resaved AP placement and recalc RF prediction. Antennas are all set to other as the 1242 are being transmitted across a Mobile Access DAS.

I'm seeing clients and rogues, but no AP heat maps. Any ideas what is happening

3 REPLIES
Hall of Fame Super Silver

Re: No Heat Maps being displayed in WCS

In the layers under Access Points, you can only check 802.11a or 802.11b/g. If you have checked 802.11a + 802.11b/g then you will see no heat map.

-Scott
*** Please rate helpful posts ***
New Member

Re: No Heat Maps being displayed in WCS

Fixed that and had to change AP Antennas to defualt rubber ducks. The 'Other' selection doesn't seem to have a radation pattern associated with it.

Thanks

New Member

Re: No Heat Maps being displayed in WCS

We just ran into this. we upgraded from WCS 4.2 to 5.2 and the default filters were all selected so we were not seeing the heatmaps. This was the solution for us.

Thanks

151
Views
10
Helpful
3
Replies
CreatePlease to create content