Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

No output from "show cdp neighbor" on wireless trunk

I have several AIR-AP1242AG-E-K9, sw 12.3(8)JA2, configured on 5GHz as bridge with VLANs. They works fine with EAP-FAST authentication and AES ecryption, only the "show cdp neighbor" does not show the associated bridges, unless I configure "interface Dot11Radio1" and "interface Dot11Radio1.x" (with the native encapsulation) with the "no cdp enable" command. Then the "show cdp neighbor" show its wireless neighbors - on one of "tagged" wireless interfaces.

Have you got similar experience? Do you know reason of this behavior?

Regards Frantisek

1 REPLY
Bronze

Re: No output from "show cdp neighbor" on wireless trunk

I think you are running into a bug here. The bug-Id is: CSCdx64384

159
Views
0
Helpful
1
Replies