Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Non Cisco client radios and 1232AG access point problems

We have two 1232 APs running 12.3(8)JEA software and about 15 USB radios (B/G) made by Via that are having problems staying connected. The problem is very intermittent and is driving us crazy!! We are also seeing an issue with a NetGear PCI card taht's in a PC. We recently disabled all the 802.11G radio settings but didn't see much improvement.

Thanks

2 REPLIES
Hall of Fame Super Gold

Re: Non Cisco client radios and 1232AG access point problems

Can you post your config?

New Member

Re: Non Cisco client radios and 1232AG access point problems

Radio Settings:

A radio is off G is on

Wep (short key) is enabled

All OFDM rates are disabled

1,2,5,and 11 mb = Require

CCK Transmit = max

OFDM Transmit = max

Client Power local = Enable

Limit Client Power = Max

Channel is 11 (other AP is 6)

World mode = disable

Country = blank

Preamble = short

Rx and Tx Antennas = diversity (ap has two whips)

External antenna = disable

Traffic stream = disable

Aironet extensions = disable

Ethernet Encapsulation Transform:= RFC1042

Reliable Multicast to WGB: = Disable

Public Secure Packet Forwarding:= Disable

Short Slot-Time: = Enable

Beacon Privacy Guest-Mode:= Disable

Beacon Pd. = 100

Max Data Retries = 64

Frag threshold = 2346

Data Beacon (DTIM) = 10

RTS Max retries = 64

RTS Threshold = 2347

Route Parent Time Out = 0 rest are blank

Security: Global SSID Manager

SSID Interfaces are set for both A and G radios even the A radio is not enabled

Method accepted is Open Authentication with no addition

Server priorities are both at default

Key Mgmt = None

CCKM and WPA are not checked

WPA shared key is blank

Accounting is left at defaults

General settings box--nothing checked everything left blank, disabled or none

Multiple BSSID Beacon Settings box--nothing checked or enabled

Guest Mode/Infrastructure SSID Settings = Single BSSID

Hope this is what you were looking for, let me know if you need anything else.

Thanks

248
Views
0
Helpful
2
Replies
CreatePlease to create content