Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Non ETH lines - BW/speed requirement - LWAP to WController reg./comm.

Not long ago I search some non wireless information and I found some document on Cisco WEB, which say about LWAP to WCotroller communication sensitivity and minimal troughput requirement. There was an info about "serial" line BW bandwidth/speed requirement - LWAP to WController registration/communication. Can anyone say me anything else about it?

1 REPLY
Anonymous
N/A

Re: Non ETH lines - BW/speed requirement - LWAP to WController r

Make sure the time/date is correct on the controller.Give it a couple of minutes to see if the AP joins.

If that doesnt solve the problem, place the controller in master controller mode, once again give it a couple of minutes.

If they still wont join, upgrade the controller code

112
Views
0
Helpful
1
Replies