Non ETH lines - BW/speed requirement - LWAP to WController reg./comm.

[omrh]

Not long ago I search some non wireless information and I found some document on Cisco WEB, which say about LWAP to WCotroller communication sensitivity and minimal troughput requirement. There was an info about "serial" line BW bandwidth/speed requirement - LWAP to WController registration/communication. Can anyone say me anything else about it?

[#2]

Make sure the time/date is correct on the controller.Give it a couple of minutes to see if the AP joins.

If that doesnt solve the problem, place the controller in master controller mode, once again give it a couple of minutes.

If they still wont join, upgrade the controller code