Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Not able to change start and end date in WLSE-reports-trends

Not able to change start and end date in WLSE-reports-trends

Report Name-Group Performance Report: RF Utilization

3 REPLIES
Bronze

Re: Not able to change start and end date in WLSE-reports-trends

Are the boxes with the pulldowns there? Are you unable to use the pulldown or when you change the date in the pulldown do you not see a reflection in the results? Does this happen on other reports or just this one? Does the WLSE report that there is data available?

New Member

Re: Not able to change start and end date in WLSE-reports-trends

I see boxes and can select date also but as I submit the report chnage back to today date and report shows only today data. How to check data availability ?

Bronze

Re: Not able to change start and end date in WLSE-reports-trends

The only time I have seen an issue similar to this it has been due to corruption in the database. Usually it was reported after an upgrade from 2.x to 2.11. Have you recently upgraded from 2.x to 2.11? Was the patch applied prior to upgrade?

155
Views
0
Helpful
3
Replies
CreatePlease login to create content