Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Omnipeek and Cisco AP

Im trying to obtain data using an AP in sniffer and that data i would like to be send to remote PC using onmipeek .

i follow their instructions on the website but it dosn't work .

Any suggestion.

Thank you

Vic

1 REPLY
Gold

Re: Omnipeek and Cisco AP

To use Omnipeek you have to get some remote plugins from Wild Packets. You might want to make sure you have the right version.

Also make sure you disable IP-MAC address binding on the controller. This is a requirement.

There are multiple sniffers that will work with an AP in sniffer mode. I've had the easiest time setting up Wireshark, but all of the sniffers listed have been tested.

http://www.cisco.com/en/US/docs/wireless/controller/6.0/configuration/guide/c60err.html#wp1042843

252
Views
0
Helpful
1
Replies
CreatePlease to create content