Well that is prefered, but not always the case... you have to figure out why the AP is dissacociating from the RAP. One reason can be radar and using DFS channels. Since the log shows INJECTOR_DETECTED, i'm guessing this is a RAP? Maybee look at the switchport for errors? The log isn't going to tell you much unless its wireless related, you also need to take a look at your wired side.
*****Help out other by using the rating system and marking answered questions as "Answered"*****
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...