Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Packet trace on Dot0 interface

Hi,

We are using Aironet 12xx AP's and I would like to know if it is possible to do a packet trace in CLI mode.

Something like a tcpdump on the dot0 interface in order to see all in/out traffic to the wireless.

It would avoid me a 400km travel to the site for a wireshark/airpcap capture ...

Many thanks in advance for any suggestion.

PY

2 REPLIES
Gold

Re: Packet trace on Dot0 interface

There is not a tcpdump type of output on the AP but depending on what type of traffic you are looking for you may be able to see it with some of the dot11 trace print debugs.

New Member

Re: Packet trace on Dot0 interface

Thank you for the information, can you please advise on the dot11 trace commands that you tell ?

271
Views
0
Helpful
2
Replies