Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Passing DHCP through a AP1232

I have an AP1232 that allows clients to associate - no issue, but the clients cannot do not receive an IP address from my MS DHCP server. There are plenty of IP's available in the scope, and 'wired' clients receive IP addresses with no problem.

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: Passing DHCP through a AP1232

Thanks for posting the solution!

Please throw a Red Check on it so people can identify it as a solution.

Good Luck

Scott

3 REPLIES
Green

Re: Passing DHCP through a AP1232

Are the wireless clients on the same subnet (and in the same DHCP scope) as the wired clients?

Do you have any other subnets / SSIDs on the AP?

Let us know

Scott

Community Member

Re: Passing DHCP through a AP1232

The AP and DHCP scope are on the same subnet as the wired. No VLAN's - flat network.

***This issue was solved by TAC: switch port that the AP was connected too had port security enabled. Needed to be disabled.

Green

Re: Passing DHCP through a AP1232

Thanks for posting the solution!

Please throw a Red Check on it so people can identify it as a solution.

Good Luck

Scott

157
Views
10
Helpful
3
Replies
CreatePlease to create content